Steps To Follow When Dealing With Plaster Ceiling Repairs

Plaster repair is a task that a competent DIYer can handle. It is important to treat plaster finishes on the ceiling with care. Old plasters offer flexibility and quality texture. Therefore, it is crucial to maintain these qualities during your home renovation. If you are looking to repair your plaster ceilings, take the time to learn the right procedures to follow.

Analyse the Ceiling

Once you repair the cause of the ceiling damage, analyse how far the plaster has pulled away. Pushing the plaster back to its position should make it go back to its original spot. Sometimes, there may be debris in the way. Thus, you should not force the plaster back in place when you feel some resistance. 

Remove the Dirt

Avoid reattaching the ceiling unless you can vacuum all the debris above. Parts of the roof with the most damage usually have a lot of dirt. Therefore, you should remove these sections. Use a new plaster to infill these parts. Removing the pieces of the plaster with serious damage will encourage more plaster to detach. The best way to control this is by marking your repair plan. You can then use a utility knife to remove the damaged parts. Use blunt crayons when marking as pens can seep through the paint later. 

Locate the Wood Laths and Drill Holes

Any holes you drill for the adhesive need to be beneath the wood lath. That will ensure the adhesive has a solid bonding surface. During a reattachment repair, you will use trial and error to locate the lath. 

Drilling holes will introduce another challenge to the repair process. It is critical to bore the holes only through the injection surface. For instance, when reattaching from above, bore the holes through the lath. But be careful to stop before getting to the plaster. 

Inject the Adhesive

Ensure you clean any dirt from drilling before injecting the adhesive. You can get the ideal adhesive from hardware stores. The amount you purchase depends on the size of your project. A caulking gun is necessary as the tips fit into the holes. That will ensure you have a smooth process of injecting the adhesive. Pumping too much adhesive will cause more harm than good. Therefore, use a damp sponge to clean off the excess adhesive.

Secure the Plaster

The last step is pushing the plaster back in place. Using forms during the process will help spread the adhesive, allowing it to bond to a larger surface. You can use plywood squared with a layer of sheet polyethylene. Finally, secure these elements using screws or wood shores and allow 24 hours for the adhesive to set.

For more information, contact a plaster ceiling repair service.

Share